03 - Configure BTX to classify incoming Innovonics alerts and push data to XProtect

Post Reply
admin
Site Admin
Posts: 48
Joined: Sun Apr 22, 2018 1:28 pm

03 - Configure BTX to classify incoming Innovonics alerts and push data to XProtect

Post by admin » Tue Jun 04, 2019 7:19 pm

An Inovovics alerts resembles the alarm string below. Each parameter represents the following: DATE, TIME, ALARM MESSAGE, DEVICE NAME.

TO BTX: <4/24/2020><9:8:27><IntrusionAlarm:Intrusion;SCICode:1;SCI:ALARM 1><0:4:Receiver_Beam_South_01>

For standard device alarms, i.e. panic button pushed, intrusion beam crossed, etc., complete the following steps.

1) Open BTX
2) Click on the "Analytics to Milestone" tab.
3) In the alarm keyword text field, enter the alarm name of interest. NOTE: When an Inovonics device is triggered, the ALARM MESSAGE names can retrived by checking the the BIX (Bridge to Inovonics) "Log / Status" tab.


Input Alarm Message HERE
BTX_Inovonics_config2.jpg
To find the Alarm Message name for use in BTX, go to the BIX (Bridge to Inovonics) "Log / Status" tab and generate the desired alarm on the Inovonics device.
BTX_Inovonics_config1.jpg
3) Click Save.

4) Go to "Device Map" tab in BTX.
5) In the "Analytics Device Name" column, enter the Inovonics device name as reported in the the parameter of the alarm string.
6) Click "Save Mappings"
BTX_Inovonics_config2.jpg
Attachments
BTX_Inovonics_config3.jpg
Post Reply